|
|
| CDI=Corrected During Inspection | |
R=Repeat Violation | |
VR=Verification Required | |
|
|
| Violation Item
| Demerits
| Violation Description
| CDI | R | VR |
|
|
16
|
1.50
|
Food-contact surfaces: cleaned & sanitized |
Yes |
No
|
No |
4-501.114 Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration and Hardness (P) - Sanitizer with dishes was reading at 0 ppm. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under 4-703.11(C) shall meet the criteria specified under §7-204.11 Sanitizers, Criteria, shall be used in accordance with the EPA-registered label use instructions, and shall be used as follows: (C) A quaternary ammonium compound solution shall: (2) Have a concentration as specified under § 7-204.11 and as indicated by the manufacturer's use directions included in the labeling. CDI: Sanitizer was changed and read at 300 ppm and dishes were rewashed.
4-601.11 (A) Equipment, Food-Contact Surfaces, Nonfood Contact Surfaces, and Utensils (Pf) - Food debris observed in container of utensils under prep table. (A) Equipment food contact surfaces and utensils shall be clean to sight and touch. CDI: Container was moved to dish area. |
|
21
|
0
|
Proper hot holding temperatures |
Yes |
No
|
No |
3-501.16 (A) (1) Time / Temperature Control for Safety Food, Hot and Cold Holding (P) - Pan of fried chicken in front hot holding case measured below 135 degrees. PIC stated that the chicken was made an hour ago. (A) Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under §3-501.19, and except as specified under (B) and in (C) of this section, time/temperature control for safety food shall be maintained: 1) At 57oC (135oF) or above. CID: Chicken was reheated and measured between 169-173 degrees. *left at zero points due to other hot holding being in compliance* |
|
22
|
0
|
Proper cold holding temperatures |
Yes |
Yes
|
No |
3-501.16 (A) (2) and (B) Time / Temperature Control for Safety Food, Hot and Cold Holding (P) - REPEAT with improvement: One pan of corn beef and ham paninis in reach in of make unit measured above 41 degrees. PIC stated that sandwiches were placed there at 11:00 am. (A) Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under §3-501.19, and except as specified under (B) and in (C) of this section, time/temperature control for safety food shall be maintained: (2) At 41F or less.CDI: Sandwiches were moved to blast chiller since there was one more hour in the cooling process. *RESHI also advised PIC to place items on speed rack and place in walk in freezer if space is occupied in blast chiller*/*left at zero points due to other cold holding temperatures being in compliance* |
|
33
|
0.50
|
Proper cooling methods used; adequate equipment for temperature control |
Yes |
Yes
|
No |
3-501.15 Cooling Methods (Pf) - REPEAT with improvement: One pan of corn beef and ham paninis in reach in of make unit measured above 41 degrees. PIC stated that sandwiches were placed there at 11:00 am. (A) Cooling shall be accomplished in accordance with the time and temperature criteria specified under § 3-501.14 by using one or more of the following methods based on the type of food being cooled: (1) Placing the food in shallow pans; (2) Separating the food into smaller or thinner portions; (3)Using rapid cooling equipment; (4) Stirring the food in a container placed in an ice water bath; (5) Using containers that facilitate heat transfer; (6) Adding ice as an ingredient; or (7) Other effective methods. (B) When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (1) Arranged in the equipment to provide maximum heat transfer through the container walls; and (2) Loosely covered, or uncovered if protected from overhead contamination as specified under Subparagraph 3-305.11(A)(2), during the cooling period to facilitate heat transfer from the surface of the food. CDI: Sandwiches were moved to blast chiller since there was one more hours in the cooling process. *RESHI also advised PIC to place items on speed rack and place in walk in freezer if space is occupied in blast chiller* |
|
38
|
0
|
Insects & rodents not present; no unauthorized animals |
No |
No
|
No |
6-501.111 Controlling Pests (C) - Some flies present within facility. The premises shall be maintained free of insects, rodents, and other pests. The presence of insects, rodents, and other pests shall be controlled to eliminate their presence on the premises by eliminating harborage conditions. *Maintenance shall be contacted* |
|
47
|
0
|
Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used |
No |
No
|
No |
4-501.12 Cutting Surfaces (C) - Cutting boards in clean dish area should be replaced. Minor scratches on cutting board at sandwich station. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they are not capable of being resurfaced. |
|