| Violation Item
| Demerits
| Violation Description
| CDI | R | VR |
|
|
16
|
1.50
|
Food-contact surfaces: cleaned & sanitized |
Yes |
Yes
|
No |
Observed dried meat residue on the meat saw that had not been used today and a small amount of residue on the slicer press. Foodservice equipment shall be clean to sight and touch. / Food employee made sanitizer solution for the three compartment sink and it measured less than 50ppm chlorine. Proper concentration is between 50-200pm. Recommend filling up entire vat first, then adding chlorine and stirring, then testing. / Upon discussion with PIC, there is confusion as to whether sanitizer is applied to deli slice after washing and rinsing. After all food contact surfaces are washed, they must be sanitized. Continuous-use surfaces, such as the large chicken cutting table, deli slicer, meat saw, and the small carnitas cutting board and knife must be washed, rinsed, and sanitized at minimum every 4 hours.
4-601.11 (A) Equipment, Food-Contact Surfaces, Nonfood Contact Surfaces, and Utensils (Pf)
4-702.11 Utensils and Food contact surfaces shall be sanitized before use after cleaning. P
4-602.11 Equipment Food-Contact Surfaces and Utensils - Frequency (P)
4-703.11 Hot Water and Chemical - Methods (P) |
|
23
|
1.50
|
Proper date marking & disposition |
No |
Yes
|
No |
Turkey ham opened previous day did not have date label on them. Barbacoa in walk in cooler made two days ago was dated into the future of 1/8, then giving a +6 days shelf life. Items that are opened or prepared must be labeled with the date of preparation and may be kept up to +6 days from that date. Foods were labeled.
3-501.17 Date mark all ready to eat TCS foods prepared onsite and held for more than 24 hours. Pf |
|
37
|
0
|
Food properly labeled: original container |
No |
No
|
No |
Red corn flour not labeled with common name. Label all dry goods as to their contents with their common name.
3-302.12 Food Storage Containers Identified with Common Name of Food (C) |
|
39
|
0
|
Contamination prevented during food preparation, storage & display |
No |
No
|
No |
In walk in freezer, some food boxes stored on low shelves less than 6” from the floor. Raise shelving to maintain the 6” floor clearance.
3-305.11 Food Storage - Preventing Contamination from the Premises (C) |
|
41
|
0.50
|
Wiping cloths: properly used & stored |
No |
No
|
No |
Wet wiping cloth stored on large chicken cutting table. Once wet, cloths must be laundered to placed in a clean sanitizer solution at proper concentration for repetitive use. Cloths can only be used for raw animal foods and can not be shared with surfaces that contact ready to eat foods.
3-304.14 Wiping Cloths, Use Limitations (C) |
|
47
|
0.50
|
Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used |
No |
Yes
|
No |
Repair the back of the hood between it and the wall on right side to keep easily cleanable. Replace all missing cam lock covers in walk in cooler and freezer. Remove rust from wire racks in walk-in coolers and replace as necessary.
4-402.11 Fixed Equipment, Spacing or Sealing - Installation (C)
4-501.11 Good Repair and Proper Adjustment - Equipment (C) |
|
49
|
0.50
|
Non-food contact surfaces clean |
No |
Yes
|
No |
Clean shelving in walk in cooler to remove meat residues.
4-602.13 Non-food contact surfaces of equipment shall be cleaned at a frequency to prevent the accumulation of soil residue. |
|
54
|
0
|
Garbage & refuse properly disposed; facilities maintained |
No |
No
|
No |
Outside receptacles side door was open. Keep outside receptacles closed when not in use. / Dumpster is starting to deteriorate and form rusting holes around the side lifts. Replace receptacle.
5-501.113 Covering Receptacles (C)
5-501.111 Area, Enclosures and Receptacles, Good Repair (C) |
|
55
|
0.50
|
Physical facilities installed, maintained & clean |
No |
Yes
|
No |
Repair cracked floor tiles around walk in entrances and around the underground grease trap.
6-501.11 Repairing - Premises, Structures, Attachments, and Fixtures - Methods (C) |
|
56
|
0
|
Meets ventilation & lighting requirements; designated areas used |
No |
No
|
No |
Lighting measured below the required minimum 50 foot candles (fc) at the slicer table (20fc) and the hood-side of the meat saw (25fc). Increase lighting.
6-303.11 Intensity - Lighting (C) |