Select your filters and click the Search button to search for data, or click Clear to clear all filters
 
Logo Main Menu
Carteret County Health Dept
Public Health Inspections
Select your filters and click the Search button to search for data, or click Clear to clear all filters
 
  
 

Premises Information

Return to Inspections
NameTIGHT LINES PUB AND BREWING CO.
Address709 ARENDELL STREET
 
City/State/ZIP
MOREHEAD CITY NC 28557
Premise Type1 - Restaurant
CountyCarteret
Inspection Date 6/22/2026
Final Score @ Grade
95 A
General CommentsDiscussed procedures and requirements for doing kimchi and will provide further info to PIC.

Violations

 
CDI=Corrected During Inspection  R=Repeat Violation  VR=Verification Required 
Violation Item Demerits Violation Description CDIRVRComments
15 0 Food separated & protected Yes Yes No 3-302.11 - Packaged and Unpackaged Food - Separation, Packaging, and Segregation: Food shall be protected from cross contamination by separation during storage, preparation, holding, and display. P *Containers of foods in 1 dr small freezer were not covered. Container of shrimp in prep unit was stacked in another pan of shrimp. Do not stack pans in units where pans are sitting directly on top of food. CDI- Lids added and container was removed. *Improvement from last inspection.
22 1.50 Proper cold holding temperatures Yes No No 3-501.16 - Potentially Hazardous Food (Time/Temperature Control for Safety Food), Hot and Cold Holding: Maintain TCS foods in cold holding at 41F or less. P * Right side prep unit on main expo line is holding TCS foods at 47F-52F degrees. All foods that were TCS had been moved into unit from walk-in this morning and were moved back to cool. TPHC can be used to get through service if it cannot be serviced before dinner service. CDI- All TCS foods moved to walk-in to cool.
28 0 Toxic substances properly identified stored & used Yes No No 7-207.11 - Restriction and Storage: Medicines that are in a food service establishment for the employee use shall be labeled with a legible manufacturer's label and located to prevent the contamination of food, equipment, utensils, linens, and single-service and single-use articles P *Observed medicine located above single service saran wrap on back tables. Aerosol spray polish was stored with package of saran wrap near dish dump area. CDI- Chemicals and meds moved to approved area.
35 0.50 Approved thawing methods used Yes Yes No 3-501.13 (E) Thawing: Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until the time of use shall be removed from the reduced oxygen environment prior to thawing under refrigeration or immediately on completion of thawing if thawed under cold running water. *Observed multiple ROP packs of Tuna that were thawed completely in walk-in refrigerator. The label on the fish states to remove before thawing. CDI- PIC cut open packages.
41 0.50 Wiping cloths: properly used & stored No Yes No 3-304.14 - Wiping Cloths, Use Limitation: Wet wiping cloths shall be held in approved sanitizer when not in use. Sanitizer shall be free of visible soil. *Observed wet and soiled wiping cloths sitting in different locations on cutting boards throughout kitchen. CDI- PIC moved to sanitizer bucket.
44 0.50 Utensils, equipment & linens: properly stored, dried & handled No Yes No 4-903.11 - Equipment, Utensils, Linens, and Single-Service and Single-Use Articles: Store cleaned equipment, utensils, linens and packages in a clean, dry location and at least 6 inches off the floor. *Observed some of the containers holding clean dishes on clean dish rack had food debris in the bottom of them. Remove containers regularly and wash equipment so that food debris does not accumulate in containers. Ice wand needs to be wrapped in saran wrap and not placed directly on shelving that is not sanitized.
47 0 Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used Yes No No 4-101.11 - Characteristics: Multiuse finish must have a smooth, easily cleanable surface. *Ice bucket side is cracked and is not easily cleanable. CDI- PIC removed from use to purchase another. 4-101.19 - Nonfood-Contact Surfaces: Nonfood-contact surfaces of equipment that are exposed to splash, spillage, or other food soiling or that require frequent cleaning shall be constructed of a corrosion-resistant, nonabsorbent, and smooth material. *Repair rusted shelving throughout kitchen and remove rust from sides of equipment.
49 1 Non-food contact surfaces clean No Yes No 4-601.11 - Equipment, Food-Contact Surfaces, Nonfood-Contact Surfaces, and Utensils: Non-food contact surfaces and utensils shall be clean to sight and touch. *Observed gaskets on some prep units need to be detailed.Bottom unused standup reach and front sections and reach-in section of salad prep unit needs to be detailed. Water accumulating in the bottom of several prep units needs to be removed. Sides of equipment such as stove, fryers, and other units need to be detailed on the sides. Top of ice machine needs to be detailed. Shelving throughout needs to be detail cleaned due to debris and dust buildup. Detail tracts of speedracks in walk in cooler.
55 1 Physical facilities installed, maintained & clean No Yes No 6-501.12 - Cleaning, Frequency and Restrictions: All physical facilities shall be maintained in good repair and shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. *Detail clean the walls and the floors throughout, especially under and behind equipment in the kitchen, walls, and the walk-in cooler - excessive build up observed. 6-501.11 - Repairing: Floors, walls, and ceilings including the attachments such as soap and towel dispensers; light fixtures; and heat/ac vents shall be maintained in good repair. Replace broken floor tiles in kitchen - especially in dish area. Observed some small holes on some walls - fill to ensure smooth and easily cleanable.
56 0 Meets ventilation & lighting requirements; designated areas used No Yes No 6-303.11 - Intensity: The light intensity shall be at least 10 foot candles in walk-in refrigeration units and dry storage areas. 20 foot candles at hand washing and ware washing areas. 50 foot candles at all food prep areas. *Several lights bulbs out under hoods lighting in listed areas were as follows. Main grill cookline 2-10FC, prep units main cookline 10-30FC, 3-comp sink 2-8FC, and above back handsink 0.8FC. Increas lighting in these areas.