|
|
| CDI=Corrected During Inspection | |
R=Repeat Violation | |
VR=Verification Required | |
|
|
| Violation Item
| Demerits
| Violation Description
| CDI | R | VR |
|
|---|
|
13
|
1
|
Food in good condition, safe & unadulterated |
Yes |
No
|
No |
3-101.11 Food shall be safe for consumption, unadulterated and honestly presented. -P. Observed two dented cans with dents on the seams. Both were located in the walk in refrigerator. CDI, cans discarded. |
|
16
|
1.50
|
Food-contact surfaces: cleaned & sanitized |
Yes |
No
|
No |
4-601.11(A) Equipment food contact surfaces and utensils shall be clean to sight and touch. -Pf. Observed several pans stored on the clean shelf with food residue. Observed the Robocoup food processors with food debris inside the plastic part of the blade. CDI, all items placed at dish washing area for cleaning.
For more information, please visit: https://health.mecknc.gov/envhealth/food-and-facilities-sanitation or view our training videos at the following weblinks: Sanitizing Solutions - https://youtu.be/ykP2mr9CtRg , How to Test Sanitizer https://youtu.be/y0SjmnabFaY , and Cleaning and Sanitizing Food Contact Surfaces https://youtu.be/av1Rbh-lh08 . |
|
33
|
0.50
|
Proper cooling methods used; adequate equipment for temperature control |
Yes |
No
|
No |
3-501.15 Quickly cool foods. Use methods such as open/vented shallow pans, large ice baths and active stirring. Cold air must flow around product to remove the heat. -Pf Observed Caesar dressing and in house prepared potato salad with a zero degree cooling rate after 40 minutes. Both products still had over 3 hours to cool. Both products observed in deep containers and initially covered. PIC vented the products. CDI, products moved to walk in freezer where they began to cool rapidly by the end of the inspection.
For more information, please visit: https://health.mecknc.gov/envhealth/food-and-facilities-sanitation or view our training videos at the following weblinks: What are TCS Foods https://youtu.be/bRvqAETDjQU and Cooling Food Safely https://youtu.be/P6x8b1ZVOxU . |
|
38
|
0
|
Insects & rodents not present; no unauthorized animals |
No |
No
|
No |
6-501.111 Keep the premises free of insects, rodents, and other pests. Observed one small drain fly in the kitchen. Ensure the kitchen is free of pests. |
|
47
|
0
|
Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used |
No |
No
|
No |
4-501.11 Maintain equipment in good repair. Observed green shelving with chipping paint. Repair or replace the shelving. Observed cutting boards with deep grooves collecting residue. Repair the cutting boards. |
|
48
|
0.50
|
Warewashing facilities: installed, maintained & used; test strips |
No |
No
|
No |
4-501.14 Warewashing machines and the compartments/drainboards of sinks used for washing and rinsing equipment, utensils, raw food, etc. shall be cleaned before use, throughout the day to prevent recontamination of equipment and utensils, and at least every 24 hours if used. Observed mold inside the dish washing machine. Clean and sanitize the interior of the machine each day. Recommend leaving doors open to vent moisture when it is not in use. |
|
51
|
0
|
Plumbing installed; proper backflow devices |
Yes |
No
|
No |
5-202.13 An air gap between the water supply and flood level rim shall be at least twice the diameter of the water supply inlet and not less than 1 inch.-P. Observed spring for dish washing sink sprayer starting to droop due to the spring being installed up side down. CDI, spring adjusted, but it still needs to be installed properly to prevent the sprayer from reaching the the sink basins. |
|
55
|
0.50
|
Physical facilities installed, maintained & clean |
No |
No
|
No |
6-501.12 Floors, walls, ceilings including the attachments such as soap, towel dispensers; light fixtures; and heat/ac vent covers shall be clean. Caution should be used to minimize food exposure. Observed food debris collecting under shelving, especially near the freezer. Clean the floors. |
|