|
23
|
1.50
|
Proper date marking & disposition |
Yes |
Yes
|
No |
3-501.17 (A) or (B) Date mark/label all TCS foods that are ready-to-eat once opened or prepared and are to be held for more than 24 hours. -Pf. Establish a date marking system consistent with 3-501.17 (A) or (B). Additional date marking system options are found in 3-501.17 (D). Observed baked potatoes and boiled eggs being held in 2-door standing reach-in without date label, prepped on 1/21 to be used to make potato salad, per the PIC. CDI- EHS discussed with PIC, PIC had date labels marked. *REPEAT*
For more information, please visit: www.mecknc.gov/foodsafety or view our training videos at the following weblinks: What are TCS Foods https://www.youtube.com/watch?v=q0iLZb7v0UM and Date Marking Food Safely https://youtu.be/BOPsSNUajYs .
3-501.18 Discard the food requiring date labels once time/temperature window has expired, if it has not been labeled, or if the label is incorrect. -P The PIC should train and assign staff to monitor date marking to prevent the use of food products that are no longer in compliance with 3-501.17 (A), (B), or (C). Observed house Alfredo sauce being held without a date. PIC stated item was prepped on 1/20. CDI- PIC date marked item. *REPEAT*
For more information, please visit: https://health.mecknc.gov/envhealth/food-and-facilities-sanitation or view our training videos at the following weblinks: What are TCS Foods https://youtu.be/bRvqAETDjQU and Date Marking Food Safely https://youtu.be/BOPsSNUajYs . |
|
43
|
0.50
|
In-use utensils: properly stored |
Yes |
Yes
|
No |
3-304.12 (F) Containers of water used for storing in-use utensils must be maintained at a temperature of at least 135 F and cleaned at least every 24 hours or when container has accumulated soil or residue. Observed in use utensils stored in water below 135F. CDI- PIC heated water to above 135F. *REPEAT* |
|
47
|
0.50
|
Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used |
No |
Yes
|
No |
4-101.19/4-202.16 Non FOOD-CONTACT SURFACES of EQUIPMENT that are exposed to splash, spillage, or other FOOD soiling or that require frequent
cleaning shall be constructed of a CORROSION-RESISTANT, nonabsorbent, and SMOOTH material. NonFOOD-CONTACT SURFACES shall be free of unnecessary ledges, projections, and crevices, and designed and constructed to allow easy cleaning and to facilitate maintenance. Observed rusted shelving through out facility. *REPEAT*
4-501.11 Maintain equipment in good repair. Observed gaskets needing to be replaced on 2-door standing reach-in. |
|
55
|
0
|
Physical facilities installed, maintained & clean |
No |
No
|
No |
6-101.11/6-201.11 Floors, walls and ceilings shall be designed, constructed, and installed so they are smooth and easily cleanable. Floors shall be non-absorbent in areas subject to moisture. Observed baseboard needing to be repaired. |