|
2
|
6
|
Water quality: disinfectant residual provided by |
No |
No
|
No |
Observed chlorine @ 0ppm. Pool disinfectant system currently being utilized is Hayward Saline Commercial Salt Chlorine Generator. ** Maintain chlorine level at a minimum of at least 1.0ppm. Chlorine level was not able to be raised while EHS on-site. Salt system itself must raise the chlorine level to the required level; otherwise, switching back to use of the erosion feeder that remains in place is an option available if salt system needs repair/ adjustment. Immediate Suspension issued. |
|
3
|
6
|
Water quality: pool water pH |
No |
No
|
No |
Observed pH @ 8.2. ** Maintain pH 7.2 - 7.8. An attempt was made to correct pH while EHS on-site; however, pH level dropped to 6.8.
Immediate Suspension issued. |
|
11
|
2
|
Pool maintenance: diving equipment, ladders, steps and handrails properly placed, in good repair |
No |
No
|
No |
One ladder 8" from pool wall (& the other 2.5" from pool wall). ** Maintain minimum of 3" & a maximum of 6". |
|
24
|
4
|
Equipment room: approved pump, filter, and flow meter operating properly |
No |
No
|
No |
Flow meter float stuck. ** Keep flow meter operational. |
|
27
|
2
|
Equipment room: filter backwash discharged through an air gap |
No |
No
|
No |
Backwash pipe turns down into sump. ** Backwash water should discharge through a complete air gap. |
|
29
|
2
|
Dressing and sanitary facilities: required fixtures provided, clean, and in good repair |
No |
No
|
No |
Leak @ junction of one shower head fixture & column.
** Resolve.
There is a combined total of 5 toilets in the men's and women's restrooms. EHS observed 2 toilets in the restrooms w/ waste present in bowls and another toilet stall door posted with an out of service sign; CPO/ engineer states that the sensor for automatic flush feature for this particular toilet needs to be replaced. ** Check sensors for all toilets and repair/ replace sensors if necessary. |
|
30
|
2
|
Dressing and sanitary facilities: approved water source, no cross connections |
No |
No
|
No |
Over-the-rim fill spout extends ~7.5" beyond pool wall.
** Over-the -rim spout shall not protrude more than 2" beyond the edge of the pool. |