|
16
|
1.50
|
Food-contact surfaces: cleaned & sanitized |
No |
No
|
No |
4-703.11(B) After being cleaned in a mechanical dish machine, equipment food-contact surfaces and utensils shall be sanitized in the dish machine by achieving a utensil surface temperature of 160F as measured by a max/min thermometer.-P.
Observed mechanical dish machine only able to achieve a maximum temperature of 155F during inspection. Maintenance contacted during inspection. Facility shall use dish machine to wash and rinse utensils and sanitize in two compartment sink. Facility has state variance for w/r/s operations in two compartment sink. All foods already served on single use utensils.
72 hour VR required.
1.5 pts.
For more information, please visit: https://health.mecknc.gov/envhealth/food-and-facilities-sanitation or view our training video at the following weblink: Cleaning and Sanitizing Food Contact Surfaces https://youtu.be/av1Rbh-lh08 . |
|
24
|
0
|
Time as a Public Health Control; procedures & records |
Yes |
No
|
No |
3-501.19(B)(3) Follow written procedures for foods held using Time as a Public Health Control (TPHC) for 4 hours. Food shall be marked to indicate the time that is 4 hours past the point in time when the food is removed from temperature control. Pf
Observed TPHC chart not filled out indicating the time foods were placed on time.
CDI - PIC labeled with time.
0 pts. |
|
41
|
1
|
Wiping cloths: properly used & stored |
Yes |
Yes
|
No |
3-304.14(B) Hold in-use wiping cloths in properly concentrated sanitizer between uses.
Observed wiping cloths being stored in sanitizer with concentration of 0ppm quat during inspection.
CDI - Sanitizer changed to solution maintaining 400ppm quat.
Repeat. 1 pt. |
|
47
|
0
|
Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used |
Yes |
No
|
No |
4-101.19/4-202.16 Non FOOD-CONTACT SURFACES of EQUIPMENT that are exposed to splash, spillage, or other FOOD soiling or that require frequent
cleaning shall be constructed of a CORROSION-RESISTANT, nonabsorbent, and SMOOTH material. NonFOOD-CONTACT SURFACES shall be free of unnecessary ledges, projections, and crevices, and designed and constructed to allow easy cleaning and to facilitate maintenance.
4-202.11 Multiuse food contact surfaces shall be smooth, free of open seams, cracks, chips, pits, sharp internal angles, crevices and assembled to allow access to clean. -Pf
Observed unsealed wood being used to support drying rack table legs in dish pit. Repair or replacement necessary. Observed multiple cracked and chipped rubber spatulas being stored as clean during inspection.
CDI - Rubber spatulas voluntarily discarded.
0 pts. |